0

I have a two node Availability Group system which hosts several AvailabilityGroups. Each AG has it's own listener.

The system was set up in an IP-subnet with very few free addresses left. How can i create new AvailabilityGroups in a new subnet?

subnet selection screen, only one subnet. Want another there.

1 Answer 1

1

I assume that you do not want to setup a multi-subnet clustering where each node is setup on a different subnet.

To be able to add a listener on a new subnet in the cluster the cluster computers need to be on that subnet sou you will need to add ip addresses on the new subnet to the existing network adapters on the servers (or install dedicated ones) and then you can add ip address on that subnet to the Availability Group. Then you will need to setup routing so other computers can connect to the listener or have the computers on that will connect to the listener on that subnet as well.

Depending on your network infrastructure and routing setup it might even be simpler to change the subnet mask to get more ip addresses. Going from 10.0.12.0/24 to 10.0.12.0/23 (mask: 255.255.254.0) would give you 256 more ip addresses to play with.

1
  • Right answer - thank you! Finally we did not implement the suggested solution because of the static route requirement.
    – MHeld
    Jul 16, 2021 at 11:28

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.